Arduino

DFRobot GPS Shield for Arduino Code: TEL0044

The DFRobot TEL0044 GPS Shield adds GPS reception capability to Arduino boards and uses the u-blox LEA-6H receiver. KickStart technology speeds up acquisition in weak-signal conditions, while...

The DFRobot TEL0044 GPS Shield adds GPS reception capability to Arduino boards and uses the u-blox LEA-6H receiver. KickStart technology speeds up acquisition in weak-signal conditions, while SuperSense Indoor GPS supports the reception and tracking of very weak signals. The integrated antenna supervisor supports external and active antennas.

The receiver...

See Description & Specifications See Description & Specifications
99 20 €
Delivery by Wed, 25 Nov
14,00 €   shipping cost
Sent from Greece
From Top Electronics 4.9 (38)

Learn more about invoicing

Description & Specifications

The DFRobot TEL0044 GPS Shield adds GPS reception capability to Arduino boards and uses the u-blox LEA-6H receiver. KickStart technology speeds up acquisition in weak-signal conditions, while SuperSense® Indoor GPS supports the reception and tracking of very weak signals. The integrated antenna supervisor supports external and active antennas.

The receiver supports GPS and SBAS, as well as GLONASS, and is Galileo-ready. Integrated Flash memory allows firmware updates and settings storage. The package includes the GPS Shield and a passive antenna.

  • Type: Shield
  • Receiver: u-blox LEA-6H
  • Reception technologies: KickStart, SuperSense® Indoor GPS
  • Supported systems: GPS, SBAS (WAAS, EGNOS, MSAS), GLONASS, Galileo
  • Interfaces: 1 UART, 1 USB, 1 DDC compatible with I2C
  • Navigation update rate: Up to 5 Hz (ROM version), 2 Hz (Flash version)
  • Position accuracy: 2.5 m CEP
  • SBAS accuracy: 2.0 m CEP
  • Navigation sensitivity: Up to −162 dBm
  • Cold-start sensitivity: −148 dBm
  • Anti-jamming technology: Yes
  • Assisted GPS: AssistNow Online and AssistNow Offline, OMA SUPL compatible
  • Power management: Configurable
  • Power supply: 2.7–3.6 V
  • Power consumption: 117 mW at 3.0 V in continuous mode, 33 mW at 3.0 V in power-saving mode at a 1 Hz update rate
  • Backup power supply: 1.4–3.6 V, 22 μA
  • Operating temperature range: −40–85 °C
  • Flash memory: Integrated
  • Backward compatibility: Hardware and firmware
  • Package contents: GPS Shield, passive antenna

Manufacturer

Product Number
TEL0044
Type
Shield
Board Model
-
Chipset
-

Important information

Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.

99,20 €
14,00 €   shipping cost