It is electronically controlled and with 3i technology provides precise temperature up to maximum performance.

With pressure fluctuation compensation it prevents sudden temperature changes.

It has the ability to limit the temperature for burn protection and child safety.

The indicator LED light shows when the device is in operation.

Energy and water savings of up to 30% through electronic power control with 3i technology.

Three sensors ensure the precise delivery of the desired temperature. Thus, only the amount of energy that is truly needed is consumed, without the need to add cold water to the tap, resulting in maximum energy efficiency, without losses in storage tanks or pipelines.

Suitable for use with preheated water (e.g., in combination with a solar water heater or heat pump).

• Very good energy efficiency thanks to electronic power control
• Precise temperature selection from 20°C to 60°C
• The temperature limit can be set to 43°C, 50°C, or 55°C
• Suitable for showers

The instant water heater is a type of water heater that heats water in real-time. It only heats the water that passes through it at that moment. This means there is no hot water storage tank. This has many advantages, such as energy savings, since only the water that is used is heated, and longer lifespan, since there is no water tank and no accumulation of salts on the resistance and other components.

It operates with electricity and is single-phase.

The instant water heater has a cold water inlet pipe, which passes through the resistance, heats up, and exits through the hot water outlet pipe. A necessary condition for the instant water heater to initially operate is that the pressure of the incoming cold water is not too low.

The water temperature is regulated by a thermostat so that it does not exceed a maximum value. The temperatures that the hot water reaches are preset so that one can use the hot water directly, without the need to mix it with cold water.

The maximum temperature it can reach for hot water production is 60 °C, while the maximum water flow rate reaches up to 5 liters per minute. Indicatively, 38-42 °C degrees are standard for shower use.

• It is small in size and does not take up much space.
• There are no energy losses, as only the water that is used at that moment is heated. Therefore, we save on the electricity bill. In a classic water heater, the hot water that is not used goes to waste.
• The hot water used in the instant water heater is used as is, without mixing with cold water, as happens in a classic water heater. Thus, we also save water, in addition to electricity.
• We do not need to wait for the water to heat up. As soon as we turn on the tap, hot water runs in a few seconds. The classic water heater takes a few minutes, depending on its size.
• The hot water never runs out. As long as we have the tap open, we will have hot water.