- The toilet waste pump with built-in macerator is small, compact, and resistant to hot water up to a temperature of 80 °C. The device is equipped with three water inlets and one outlet and is capable of reliably transferring wastewater to a height of 7 meters or a distance of 40 meters. It is therefore the ultimate low-cost solution for sewage problems, as it allows for the safe transfer of waste from the most remote location of the house below the water flow level.
- The waste pump is powered by a powerful 450-watt motor, which ensures the shredding of wastewater before it is transferred through a 32/40 mm pipe and allows the device to pump 100 liters per minute. While the silent motor will automatically start the pump for a short time once a certain water level is reached inside the tank, if manual extraction of the wastewater is needed, you must open the switch cover. This WilTec toilet waste pump does not require special treatment or maintenance beyond periodic descaling. The frequency thus depends on the hardness of the water in your area.
The pump can be easily connected to the toilet outlet and offers 3 additional inlets that can be connected to showers, bathtubs, sinks, dishwashers, or washing machines. Thus, the unused inlets can be easily sealed with the seals included in the delivery scope.
Features
- The toilet waste pump with built-in macerator is small, compact, and resistant to hot water up to a temperature of 80 °C. The device is equipped with three water inlets and one outlet and is capable of reliably transferring wastewater to a height of 7 meters or a distance of 40 meters. It is therefore the ultimate low-cost solution for sewage problems, as it allows for the safe transfer of waste from the most remote location of the house below the water flow level.
- The waste pump is powered by a powerful 450-watt motor, which ensures the shredding of wastewater before it is transferred through a 32/40 mm pipe and allows the device to pump 100 liters per minute. While the silent motor will automatically start the pump for a short time once a certain water level is reached inside the tank, if manual extraction of the wastewater is needed, you must open the switch cover. This WilTec toilet waste pump does not require special treatment or maintenance beyond periodic descaling. The frequency thus depends on the hardness of the water in your area.
The head pump
Although the maximum pump head can reach up to 7 meters in height and the maximum distance can reach up to 40 meters, the overall capacity of the pump depends on the ratio of these two values. 1 meter of pump head is equivalent to 10 meters of draw, assuming that the slope of the drainage inlet is 1%.
- Pump head: 7m. - Distance: 10m
- Pump head: 6m. - Distance: 20m
- Pump head: 5m. - Distance: 30m
- Pump head: 4m. - Distance: 40m
Devices installed in the basement in most cases need to cover a pump head of a maximum height of 4 meters, which means that the waste pump will still be able to cover a distance of 40 meters, which is usually more than enough.
Instructions
Check valve
The check valve needs to be installed at any cost and can be placed as close as possible to the horizontal pipe. A missing check valve could cause sewage to flow into the waste pump and consequently cause the motor to run continuously, which could eventually damage the device due to overheating.
Pipes & Tubing
The close placement of the rising pipe to the waste pump extends the device's longevity.
The pump is equipped with a powerful motor that quickly creates high pressure levels. It is recommended to use either glued PVC pipes or copper pipes. If necessary, the flow rate can be reduced by adding additional angles. The use of 2 separate 45° angles does not impede the flow as much as a 90° angle would.