The Epsolar DuoRacer DR-3210N-DDS charge controller uses MPPT technology to charge two batteries simultaneously in a photovoltaic system. It supports photovoltaic power of up to 390 W in a 12 V system and up to 780 W in a 24 V system, with a maximum open-circuit voltage of 100 V. Maximum power point tracking efficiency is at least 99.5%.
BATT1 can be a Sealed, Gel, Flooded, LiFePO4, or Li-NiCoMn battery, while BATT2 supports only lead-acid batteries and automatically detects the system voltage. Both batteries must have the same voltage. The controller features an LCD, an AES control signal for a car refrigerator, the Modbus protocol, and an RS485 communication port. It has an IP33 rating and protection against overcharging, over-discharging, and reverse PV or battery connection.
- Type: MPPT
- Maximum system voltage: 24 V
- Maximum charging current: 30 A
- Supported battery voltage: 12 V / 24 V
- Maximum photovoltaic power: 390 W at 12 V, 780 W at 24 V
- Maximum open-circuit voltage: 100 V
- Number of batteries charged: 2
- BATT1 battery types: Sealed, Gel, Flooded, LiFePO4, Li-NiCoMn
- BATT2 battery type: Lead-acid
- Display: LCD
- MPPT tracking efficiency: ≥99.5%
- Communication protocol: Modbus
- Communication port: RS485, 5 V / 200 mA
- Control signal: AES
- Protection rating: IP33
- Protections: Overcharging, over-discharging, reverse PV and battery connection
- Type
- MPPT
- Maximum Voltage
- 24 V
- Maximum Short Circuit Current
- 30 A
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.