This particular glass was purchased solely due to reviews that mentioned it does not leave gaps. Unfortunately, that is not the case. The glass leaves a gap all around, specifically 1 mm on the camera side, 2 mm on the side edges, and 3 mm on the logo side of the device (gaps that should not exist since the device does not have a curved screen surface at the junction with the frame, therefore the glass can be cut with great precision and fit perfectly with the frame). These sizes may seem insignificant between the frame and the protective glass, but this minimal unprotected area will eventually absorb the impact energy in case of a fall. Additionally, the evaluation does not concern individual defective products in terms of their dimensions, as the cutting equipment settings are exactly the same for this specific tempered glass code. Truly a shame. Otherwise, as long as the screen is thoroughly cleaned and the application is done in a space with as little dust as possible, the adhesion is flawless. So it was installed with the hope that, in case of a fall, it will not "find" the uncovered area. We shall see...