The Powermat PM-PDM-1200 electric paint sprayer applies paint hydraulically by pressurizing and spraying it without air. Suitable for use on standard building substrates, interior and exterior walls, and steel surfaces. It can be used with emulsions, acrylic and plastic paints, latex paints, water-based varnishes, varnishes and enamels. It allows for horizontal and vertical painting.
The piston pump is powered by a DC motor. If you stop for a few minutes, lock the trigger and immerse the nozzle in a suitable solvent or, for water-based paint, in water to prevent the paint from drying. To clean a clogged nozzle, rotate it 180° from the SPRAY position to the CLEAN position. If this does not clear it, check the filter in the spray gun handle.
- Power supply: Mains
- Power: 1200 W
- Maximum operating pressure: 220 bar, constant
- Flow rate: Up to 1.5 L/min
- Maximum viscosity: 110 DIN-s
- Maximum nozzle diameter: 0.48 mm
- Motor type: DC
- Pressurizing mechanism: Piston pump
- Hose length: 7.5 m
- Cable length: 10 m
- Weight: 5.9 kg
- Equipment: Paint unit, suction hose with filter, spray gun with nozzle, 50 cm spray gun extension, 250 ml TSL lubricating oil for maintaining the upper seals, 515 nozzle with a 0.015" orifice, 50° spray angle and approximately 0.87 L/min flow rate, 517 nozzle with a 0.017" orifice, 50° spray angle and approximately 1.13 L/min flow rate
Main Specifications
- Power Source
- Electric
- Nozzle Diameter
- 0.48 mm
- Flow Rate (L/min)
- -
- Maximum Viscosity (DIN-s)
- 110 DIN-s
Battery Specifications
- Lithium
- No
Current Specifications
- Power
- 1200 W
- Cable Length
- 10 m
Features & Functions
- Container Capacity
- -
- Net Weight
- 5.9 kg
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.