It is an excellent product with easy programming and for the three months I have been using it, it works perfectly. If anything changes along the way, I will update!

Unfortunately, while it easily copied the genuine control, it does open the garage door but does not close it afterwards, and additionally, it gets stuck in the mechanism of the garage door that closes automatically after 1 minute.

I tried it several times and only with this control did it have this issue. As soon as I opened it with the genuine one, the door opened and closed automatically as it should.

Unexpectedly good choice!
Programming for the garage door opener remote control!
Check before ordering, the board on the garage door mechanism, to be compatible (MHz, non-rolling code, etc.).
If these are compatible with the current remote control, the rest is easy.
The instructions on the back of the packaging are fully valid!

Perfect, small, sturdy. Only 10'' for the copying process. Its performance in relation to its price is the best. My locksmith asked me for 20€ for a similar one. I bought 2 and will order 3 more

Indeed much nicer and sturdy than the controller it would replace, but unfortunately it didn't work.
Also unfortunately, I had bought two and of course I tried both. I followed the instructions faithfully, again and again.
For similar ones on YouTube, they show that it's easy, but no matter how much I struggled, they simply didn't work.
If I find a way to make them work, I will come back

More beautiful and sturdy than another similar controller that I bought, but while the other one worked fine, this specific controller doesn't work.

I programmed it in less than 10 seconds.
I watched a video on YouTube.
The quality will show if the buttons will hold up, but for now they are working perfectly and have a great range.

To perform a reset, you need to press A and B simultaneously, and when the LED starts flashing, without releasing A, press B three times. For copying, hold the two remote controls back to back and press A continuously with the button you want to copy until the LED stays steadily lit. If everything is done correctly, it will work.