It could be better in its fastening, and I say this because the screws with the nuts need to be held from both ends with the appropriate tools, otherwise they spin and don't tighten properly, and some areas are difficult to access. Additionally, I would like the locks used for mounting and removing the angle wheel, as well as for placing and removing cutting material, to be a much easier process because they have made it very difficult. As for cutting, it seems to do well, decently, because it also requires a bench to secure and fasten. I will also mention a "luxury". I would like the angle wheel to be located between two locks (arms with which we raise and lower the wheel for cutting) instead of just one, for more stability