The film does not hold if you rub with water and leaves marks on the paint, and now it needs polish and buffing. The final layer for protection evaporates immediately and does not add shine. The result is mediocre; I will go over it again with K3000 and 4000 by hand for a better result

It does what it should. Scrub by hand with water. Use the brush only for polishing. Be careful: do not apply the final protective film in sunlight or heat because it creates bubbles, and when it dries they remain and are visible.

The results are excellent. One headlight was extremely yellow and now looks like new. The work was done by hand and not with a drill.

Very good for its price, it polishes cloudy and worn headlights, but you should always be careful to have enough water when rubbing the surface, and it's also good to have a good masking tape because the one included is minimal and thin

I first saw the video on YouTube. You have to keep pouring water while sanding, otherwise it will turn out badly. I sanded one headlight with a drill, the other by hand. I should have sanded both by hand. By hand, you can better reach the grooves of the headlight and you can do horizontal sanding at the end, so when you apply the cream, any imperfections won't show. Also, with the drill I overdid the sanding. When you finish sanding, you feel a bit desperate, the headlight looks terrible. I then applied the cream to both headlights with the drill and the orange sponge. The result was mediocre. My bad luck was that the cream was very dry and the drill struggled and the battery ran out. I used the second pack with a little water to soften the cream but it turned into soap, it's better to use it completely dry and have the drill fully charged. The varnish doesn't improve much.

The truth is that with the components it has inside, you can make the headlights look new and it is very cheap; a similar 3M set costs 50 euros. Now, as for the result, it is 100% in your hands. For example, if you give the set to a professional, they will make them look new. By yourself, you won't achieve the 100% perfect result you dream of, but you can do a pretty good job. I, for instance, the headlights became unrecognizable compared to how they were before, but there are some small scratches left; also, I lost a bit with the screwdriver and even though I used masking tape, I made a small scratch on the grille.

I got it to try on old lanterns. The cream was mediocre. It was more like clay. I got another cream and in the end, they turned out a little better than they were.

As you can see in the photo, the result is very good. For the first time I did it by following the instructions. I adapted the base to a drill screwdriver because it needed quite a bit of sanding at low speed, of course. Be careful to wet it often at each sanding stage, otherwise you will heat it up and melt the grated plastics from the lantern. At least in my case, as I did it with the electric one!

perfect result

It does a pretty good job and easily. On very foggy headlights, the difference in the result is very significant and is enough for a comfortable de-fogging without stress. On headlights with moderate fogginess, it can do 2 cleanings and still have some paste left over. The polish that goes on at the end for protection is a bit minimal. Also, with a little searching, you can find replacement sandpapers with adhesive as replacements for the grinder, so you have the kit for future uses. SOS be careful with the sandpapers because the hard edges can easily scratch the area around the headlights if they slip. That's all, otherwise it's worth it.

Everything is good. The materials included are sufficient and more than enough. Very user-friendly and with clear instructions. With a simple drill and low speeds, you can get the job done. I have my reservations about the durability over time. I might finish it with a good varnish with UV protection. Very good price!

It works, mine were very yellow and one of the headlights has a small crack so it was even worse than the other, the good one made it perfect, the cracked one brought it to 90%.
I won't go for headlight restoration with this product in my hands again.
WARNING! Wet the sandpaper at the beginning, it says so in the instructions, I read it and for some reason I didn't do it and scratched the headlight myself.

very good job, they become clean again, it does what it promises, just needs a little patience and give time to the penultimate step with the paste, if you have done a good job in the first steps the paste will perfect it and you will have a good result

It does the job but the instructions are not sufficient. To polish the headlights, it requires some tricks that are not mentioned on the box.

Good product. It has everything you need inside. It would be good to have a handle because I think you can do a better job with glass paper. Except for the cream, where I saw better results with the screwdriver. Attention. Cover around with a larger cardboard

The kit works. It has everything you need, and if you have a variable speed drill to effectively sand with the right sequence of sandpapers, you will see positive results. The polish for finishing is of very good quality. No comparison to some kits that come with a yogurt-like polish that just caresses the surface. In my case, the headlight was so dull that you couldn't see the mirror inside. After the intervention, it is two clicks below new. The job did not require more than 10 minutes of attention.

I did what it said in the instructions with the sandpaper, using soap cleaner, with the accessory it has and with my hand in difficult areas. The result surprised me by doing the job by hand, there is material left over for future use with everything included. As for the durability, time will tell, I spent about half an hour. Having as a compass the comments I read, all good, value for money 100% the product.

Excellent value for money and the items included in the package are very good. The set is very good if used correctly and quickly with at least one package for the polish and UV protector. Each package can be used for 4 headlights, not just 1. On the other hand, each sandpaper produces two headlights. It should be noted that manual use was done and it has the results of the photo. Simply, the polish requires a quick hand. Buy without fear