INSTRUCTIONS: Surfaces must be clean and dry. Ideal application temperature 15-25°C. Shake the spray for 2-3 minutes. Spray crosswise from a distance of 25 cm. Create 3-4 layers of sprayplast with a 5-minute interval between each, especially on corners and curves so that the film peels off easily afterwards. Completely dry after 2 hours.

FILM REMOVAL: After 48 hours. It is recommended to remove the film at a temperature above 15°C. Lift the film at a suitable point and pull it to detach. This is easy if you have created 3-4 layers of sprayplast during application.

Danger!

• H222-H229 Extremely flammable aerosol. Pressurized container. May burst when heated. Causes skin irritation.
• Harmful to aquatic life with long-lasting effects. If medical advice is needed, have the packaging at hand.

Precautionary statements:

• P102 Keep out of reach of children.
• P260 Do not breathe mist.
• P210 Keep away from heat, hot surfaces, sparks, open flames, and other ignition sources. No smoking.
• P251 Do not pierce or burn, even after use.
• P211 Do not spray near an open flame or other ignition source.
• Wash your hands thoroughly after use.
• Avoid releasing the contents into the environment. Wear protective gloves.
• If it gets on your hands, wash with plenty of water. If irritation persists, seek medical advice.
• Do not expose to sunlight or temperatures exceeding 50°C.
• P501 Dispose of contents/container in accordance with local/national/international regulations.

Supplementary statements: Without adequate ventilation, explosive mixtures may be formed.