The Epsolar XTRA 3415N charge controller uses MPPT technology with a tracking efficiency of over 99.5% and identifies the photovoltaic panels’ maximum power point to make use of the energy generated. It supports 12 V, 24 V, 36 V and 48 V battery banks, with a maximum charging current of 30 A. The built-in display shows system status, while the RS485 port uses the Modbus protocol.
It supports LiFePO4, AGM, Gel and lead-acid batteries, with a lithium battery activation function and temperature compensation for lead-acid batteries. The constant-voltage output can power loads directly from the photovoltaic panels when there is sufficient sunlight, even without a battery connected. It features IP33 protection and electronic protections for the photovoltaic circuit, battery and loads.
- Type: MPPT
- Maximum charging current: 30 A
- Battery voltage: 12 V, 24 V, 36 V and 48 V
- Maximum photovoltaic power: 390 W at 12 V, 780 W at 24 V, 1170 W at 36 V and 1560 W at 48 V
- Maximum photovoltaic voltage: 150 V
- MPPT tracking efficiency: Over 99.5%
- Battery compatibility: LiFePO4, AGM, Gel and lead-acid
- Display: Built-in
- Output: Constant voltage
- Communication: RS485 port with Modbus protocol
- Self-consumption: Less than 20 mA
- Enclosure protection: IP33
- Electronic protections: Photovoltaic and load short circuits, discharge, overcharging, load overload, reverse photovoltaic polarity and incorrect battery polarity
- Weight: 2.07 kg
- Dimensions: 255 × 187 × 67.8
- Type
- MPPT
- Maximum Voltage
- 48 V
- Maximum Short Circuit Current
- 30 A
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.