This is a super mini solar LiPo charger based on the CN3065 - a lithium battery charging management chip. The solar charger allows you to harness the maximum possible energy from your solar panel or other photovoltaic device and charge it into a rechargeable LiPo battery. Installation is simple, just connect your solar panel to one side of the charger and your battery to the other and you can start charging!

The output of the solar charger is designed to charge a single lithium polymer battery. The load should be connected in parallel with the battery. By default, the solar charger is set to a maximum charging current of 500mA with a maximum recommended input of 6V (minimum 4.4V). It is recommended not to charge batteries at currents greater than their nominal capacity.

• Solar panel input: 4.4-6V
• Maximum charging current: 500mA
• Interface: 2-pin JST connectors (or PH2.0)
• Short-circuit protection
• Continuous charging current up to 500mA
• Battery status indicator (Red: Charging, Green: Charged)
• USB charging support (Micro-USB Connector)

Size: 2cm x 4cm