- We set the multimeter to the DC voltage setting and to the range up to 2 Volts
- We place one end of the instrument on the left screw and the other on the right. The reading should be 1 Volt or higher. If it is below 1 Volt, we replace it with the spare part
- The base does not need replacement
Description
Specifications
- Type
- Protective Anode / Stopcor
- Material (Furniture)
- -
- Thread Size
- -
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.