I did a 3x2 rug, 2 coats. The rug has been on the balcony in the sun and wind for 3 days and it still hasn’t dried, nor has the smell gone away. A little water fell on the rug on the side where I applied the glue, and the glue turned white and wet again. What will happen if we wash the whole rug normally????!!!

If you want to repair your carpet, use the product after cleaning the underside of the carpet and only in a well-ventilated area.... as it smells quite a bit and takes a long time to dry!!! Unfortunately, it smells a lot at first. Personally, I couldn't place it in the children's room without washing it and leaving it for several days (summer) spread out on the balcony.... After a phone call with the company, they told me it is human-friendly (even though it smelled quite a bit for days even after re-washing the carpet!!!!!).... Nevertheless, it did its job.... It stopped the polymerization of the already existing non-slip layer that the carpet had as well as the retention of the fringes

It is very good. On a carpet that I was going to throw away because it kept shedding this yellow powder and was slippery, it became perfect. Of course, I applied it 3 to 4 times.

It works if you follow the instructions perfectly. I glued the worn-out underlay of a 70s rug that was rubbing against sand. I will need a second package though, as it recommends two coats for greater durability. I applied it with a synthetic brush that can be cleaned with water and soap afterwards. If you make any mistakes, wipe them off before the product dries.