The 3Doodler Start Plus 3D pen allows children to create three-dimensional designs using ECO cartridges, which harden a few seconds after extrusion. The printing material is warm but not hot, so it can be shaped by hand. LED indicators show heating, readiness and charging.
It works wirelessly for 45–60 minutes on a full charge and can also be used while connected via USB. Heating a new cartridge takes 10–15 seconds. The extrusion button starts and stops the flow, while a quick double press retracts the cartridge.
- Recommended age: From 6 years
- Type: 3D pen
- Educational approach: STEM
- Printing technology: FFF (Fused Filament Fabrication)
- Printing material: Compostable plastic in ECO cartridges
- Cartridge diameter: 2.5 mm
- Cartridge length: 15 cm
- Cartridge length after melting: 150 cm
- Nozzle width: 0.77 mm
- Maximum nozzle temperature: 65 °C
- Preheating time: 0.5 minutes
- Printing speed: 10 mm/s
- Power supply: USB, 5 V
- Maximum power: 5 W
- Operating time: 45–60 minutes on a full charge
- Housing material: Plastic
- LED indicators: Activity, heating, readiness and charging
- Colour: Yellow and turquoise
- BPA content: BPA-free
- Certification: RoHS
- Dimensions: 138 × 41 × 35 mm
- Weight: 91 g
- Package contents: 3D pen, 2 packs of ECO cartridges (48 pieces), USB cable, instructions in Polish and a design book
Dimensions
- Type
- 3D Pens
- Age
- 6 + years
- Magnetic Tiles
- No
- Kinetic Sand
- No
Educational Value
- Montessori Method
- No
- STEM
- Yes
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.