The ST739 converter supports the conversion of media from 100Base-TX to 100BASE-FX type optical fibers. Designed based on standards IEEE 802.3i, IEEE 802.3u, IEEE 802.3x, the ST739 is intended for use with single-mode optical fiber cables.

• Low power consumption
• Stable performance
• Multiple protections
• Plug & Play

Technical Specifications:

• Controller-processor: Marvell 88X3310
• Applicable Network: 10 Gigabit Optoelectronics Transceiver (Support bi-directional conversion)
• Wavelength: Single mode: 1310/1550nm, DFB: 1260~1610nm
• Outgoing fiber power: 0 dBm ~ -3 dBm / -5 dBm ~ -10 dBm
• Receiving sensitivity: ? -26dBm
• Single wavelength bandwidth: 10Gbps
• Transmission distance: Single mode: 550m~100km
• Optical power reserve: 15dbm / 20dbm / 25dbm / 30dbm
• Optical interface: standard SFP+ LC/XFP
• Physical interface: standard RJ45 copper
• Interface rate: 10G BASE-TX, full duplex/half duplex
• Network medium: Category 6 and above unshielded twisted pair
• Forwarding method: store and forward, all ports support wire-speed forwarding
• Network protocol: IEEE 802.3i, IEEE 802.3u, IEEE 802.3x Flow Control
• Flow control: IEE802.3X/IEE802.3z full-duplex flow control and half-duplex flow control
• Line sequence: self-adaptive MDI/MDIX direct connection and cross connection
• SFP+: 10G (550m~100km)
• RJ45: 10G / 1000Mbps / 100Mbps (100M UTP CAT6-A)
• Jumbo frames: 2048 byte
• Input voltage: 5-12VDC
• Input voltage: 100~250VAC
• Power consumption: 0.75W~3W
• Protection: ±15KV IEC61000-4-2 Air Gap Discharge
• Dimensions: L118 x W86 x H28mm

Package Contents:

• 10G Fiber Media Converter
• Power supply