It fits exceptionally well! You need to wet it thoroughly with the special spray so that it can be applied properly. Use the spatula to remove any water bubbles that remain, and it will be flawless. First, clean the watch thoroughly to remove dust, and use the special stickers included in the package. I wish it covered the edges a little more.

Good quality screen protection film for Apple Watch 45 mm. I have been using it for years and whenever I needed to replace it, it wasn't because of wear or scratches, but because when I put on extra cases (e.g. Spigen Rugged Armor) they push it and air gets under the edges. Okay, you get used to it, but ideally I would like it to fit properly even with a case.

Without a case though, its fit is just fine and installation is very easy. It's also important that it doesn't affect the touch at all and the screen remains just as comfortable to use.

It's definitely not a glass protector, but if you want good protection without extra bezels or "bulk" on the watch, it's just right.

Because this particular purchase comes without the "convenience" of installation with a special "base," it is definitely more difficult, but if you have patience and enough light, it's just fine and economical.

In general, it is very good, fits perfectly, and has lasted so far...

For protection film against scratches and small scuffs, excellent. It does not alter at all the perfect texture and appearance of the screen. Relatively easy to install. In the 3-pack, the first one went on 99% well, the second perfectly. You can't even tell there's a protector (photo).

Quality product that does not affect the touch on the screen. If you want to use it without a case, know that it will peel off the next minute. For a piece of gel that does not affect the aesthetics of the watch, it has excellent scratch resistance.

It applies well, but there is a small gap around the watch, meaning it does not cover the entire screen. It requires a bit of attention and the film needs to be moistened well during its installation.

good price, relatively easy installation but it doesn't last long the protector starts to peel off from the edges after 1-1.5 months of use

After you put it on carefully (watch a video on YouTube), it doesn't come off easily (I went swimming in the sea every day with this), it protects, and it doesn't ruin the screen's responsiveness. Combine it with a case that protects the edges...

The membrane goes on relatively easily, but after one week it starts to peel off or shows bubbles that don't go away. The material tears relatively easily. It's better to stay away.

I scanned it supposedly to find instructions to put it on (series 9) but there are no instructions only for previous models and different type of glass, I put it on and it filled with bubbles immediately, I pressed it a little in case they go away with the special tool but the glass broke

You need to follow the instructions that are available on YouTube in order to properly install it. Depending on the work you do, however, many times it will lift or catch dust in a corner, causing it to gradually come off. It lasts for 3 months for me until it starts to come off. However, it has also lasted me 1 week. To avoid or minimize this, you can put a transparent case on it and solve your problem.

Very good protection. Especially in my case, using a case, it does not bother and is not bothered at all. It protects from bumps and scratches, however, whoever wants it to be smooth as if it has no protection needs to change it every three months or so, because it is soft as a material and some bumps remain embossed. The result is that you need a package (it contains three protectors) approximately every year. The only way for me with not so high cost.

Those who didn't give good reviews probably didn't watch any installation videos before. Excellent fit on Apple Watch 9. Yes, it's not glass but a gelatin, it doesn't affect the colors or touch at all.

I would like to clarify that it is a film and not a glass protector. I bought it knowing this. In my opinion, it is better because glass protectors do not fit properly due to the curvature of the screen (or they do not fully cover it due to the curvature, meaning they stop at the flat part of the screen). Ideal for avoiding scratches but not strong impacts.

Very good, I will buy it again when it wears out. It requires a little attention during installation. I first put on the case and then applied it more easily

It was installed on Apple Watch 9 45mm. Easy installation, the only negative is that it leaves a little gap around. It has been combined with the Spigen slim fit case. So, 4 stars for the gap, in the future I will come back to write about durability!

Perfect in application with a nice touch feel. It doesn't seem like you have put anything on. For installation, you spray the screen enough with the liquid it has and it goes in very easily.

It is difficult to impossible to place this thing correctly without rings. If you don't have a case, it starts to come off within 3 days. I don't understand why there is no glass

This one has been installed on a watch series 9 45mm & has a perfect fit even on the edges!!
1) Attention, it is not glass but a film.
2) For proper application: After cleaning, wet the watch and the film, and then apply the film on the watch. Because there is liquid and we may not place the film correctly, we can slide it to the desired position. Once it is in the right place, remove the liquid with the provided spatula.

The worst product I have ever bought, literally a waste of money.
It definitely is not "Bubble-free" as the description says. It is impossible to remove the film without leaving fingerprints on the side that sticks to the screen. Because it is soft and flexible, it is difficult to apply it straight and if you apply it incorrectly and try to remove it, it becomes useless. No matter how careful I was, the job couldn't be done and in the end, I threw all 3 of them away.

As for protection and usefulness, I can't even tell because I didn't even get that far

I have never spent such a waste of money. It leaves a large exposed surface and it is also very thin.

First, you should clean the watch well from dust, then spray it with enough liquid provided in the box. Next, spray your fingers, especially your thumbs and index fingers, with enough liquid. Finally, after spraying the watch and fingers, spray the plastic cover with enough liquid so that you can move it when you touch it on the watch. If you can't, spray again between the watch and the plastic cover. Press with the sponge while holding the plastic cover from the opposite side and repeat from the opposite side... Now when you put it on, you will have an annoying feeling as you move your finger up, down, left, and right to access the various settings of the watch because that's where the plastic cover ends. Today is the first day of application, and we will see its durability in the future... The white spots visible in the photos are dust outside the plastic cover... If you clean it, it looks like it's not wearing anything

Although I used all three until at least one of them sat correctly, when I sprayed the screen with the cleaner and then applied the membrane, it adhered perfectly to the screen. The Spigen case is a very good combination because it prevents the membrane from lifting at the edges and does not affect the handling of the watch at all.

The worst product from Spigen that I have purchased. It is a film (not glass), which means it is very flexible and cannot be properly applied. It is also almost impossible to remove without smudging it with fingerprints, even slightly. Even with guide stickers that I applied on the top part to help with the application, it ended up with about ten bubbles (which do not go away like on a glass if you rub them, they just scratch and distort the film in those specific areas). I ruined all three that came in the package without even getting close to a decent result! Stay away from this product!

The worst for Apple Watch protection. It applies very difficultly. Durability 0. Quality below zero. Better to get the membrane you wrap food with.

Although it was easily installed, it came off while I was sleeping in less than a week. It was properly placed, and there were no air bubbles at the edges for it to come off so easily. Membranes of unknown brand that I had purchased in the past lasted ten times longer than this one. I do not recommend it.

Very good protection without distorting the image and hindering the use in all areas of the watch - you don't even realize there is protection.
For the application, you first need to watch the relevant video and it applies easily without leaving gaps

I threw away the first screen protector because it was difficult to apply and it had bubbles when I put it on... The second one had bubbles too, but they were gone the next morning! So it worked fine with the Spigen case. I hope it protects the watch :)

While it doesn't compromise the resolution and seems to provide protection, it is applied excessively difficultly.. I had to throw away one of the three films.. I will get a glass protector next time