It has been 6+ months since the purchase and first use of it, and I have to say that it is generally very user-friendly and mildly effective. In the bikini and underarm area, it takes months for any stray hairs to appear, however, on the legs, I have to persist more as they continue to grow.
After intensive use, the hairs do not completely disappear, but they become softer, lighter in color, and smoother. If you persist more, they become like fuzz and grow sparsely, and in the end, if you continue to be consistent for months, almost nothing comes out, only a semi-transparent fuzz like in the area next to the ear (in women).

To achieve results, consistency is necessary, meaning the same day and time every week! Even missing one day can delay the results.

I also want to note that I suffered from "strawberry legs" where there is a permanent appearance of spots on the legs, in the hair follicle area. If you Google it, you will understand. After prolonged use of a pumice stone and the laser machine, the problem has been significantly reduced, and I expect it to completely disappear with continuous use of the machine.

It has 3 intensity levels, a session with the low level lasts 5 minutes, with the medium level approximately 10 minutes, and with the high level around 15-30 minutes depending on the degree of the problem.

Finally, I want to say that I bought the machine for 360€ and for that price, it is excellent. Now that it has increased to 708€, it seems a bit expensive. Read the instructions carefully BEFORE using it as it mentions contraindications for those with health problems.

It is NOT suitable for all skin tones!! If you have *excessively* dark skin or have tanned from the summer, it will not work for you as it has an integrated skin tone sensor. Wait until you lighten up to use it, and it is also good to apply a moisturizer after each use.

UPDATE 14/7/2023:

After months of use, unfortunately, it malfunctioned. The red and white indicator of the sensor got tangled (see last image) while normally the sensor detects if the surface is suitable to emit the light and shows either 1. white or 2. red indicator (for unsuitable surfaces). After 2-3 minutes of use, it gets stuck on the above lights and even though it shows that it is functioning, making noise, the sensors do not work. Unfortunately, at this stage, it cannot even be turned off, so the only solution is to unplug the device. From Monday, I will visit a Braun dealership and I will update.