The Power Electronics PT539 three-phase voltage monitor is DIN-rail mounted and monitors the voltage of all three phases. It switches off the relay if any phase exceeds the set limits or falls below 50% of its nominal value, as well as in the event of a neutral-wire interruption.
The upper and lower voltage limits, along with the restart and delay times, are adjustable. Measurements are based on the true RMS value.
- Type: Three-phase
- Mounting: DIN rail
- Width: 2 modules
- Rated contact current: 8 A
- Protection: Overvoltage, undervoltage and phase sequence
- Supply voltage: 230 V
- Operating voltage range: 150–300 VAC
- Supply frequency: 48–63 Hz
- Maximum power consumption: 30 VA / 2 W at 50 Hz
- Overvoltage setting: 240–300 V AC
- Undervoltage setting: 150–210 V AC
- Hysteresis: 3% of the supply voltage (fixed)
- Restart time: 0.1–20 s
- Delay time: 0.1–20 s
- Voltage setting accuracy: ±3%
- Voltage repeatability: ±0.5%
- Timing accuracy: ±5% + 100 ms, ±3%
- Output type: 1 changeover contact
- Rated contact voltage: 250 V
- Contact power: 2000 VA (cosφ=1)
- Placement
- Rail
- Type
- Three-phase
- Rated Contact Current
- 8 A
- Digital
- No
- Protection Type
- Overvoltage, Undervoltage, Phase Sequence
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.