Luxury satin paint for interior and exterior use. It offers high coverage and whiteness. It provides a velvety surface and spreads perfectly leaving a satin finish that is resistant to frequent washing and stains.

TECHNICAL CHARACTERISTICS:

• SPREADING RATE: 14-20m² / Lt per coat
• DILUTION: First coat: 15% water. Second coat: 5-10% water
• DRYING TIME: 1 - 2 hours depending on application conditions

SURFACE PREPARATION:

• To ensure proper adhesion of the product, the surface to be painted must be cleaned from dust, grease, oils, peeling old paints, rust, mold residues, or moisture.
• For new or porous surfaces, first apply the corresponding recommended primer of the product (Step primer, Life dur water, Step plaster).
• Apply the product in 2 coats (after shaking it well) which should be spaced 1 - 2 hours apart.
• The product achieves all its mechanical strengths after 20 - 30 days.

APPLICATION CONDITIONS:

• Avoid applying the product at temperatures below 6°C and above 40°C and when the relative humidity exceeds 80%. Adverse conditions during application can alter the final properties of the paint.

APPLICATION TOOLS:

• Brush
• Roller
• Spray gun

During the work, keep the tools “wet” inside the container. Wipe off the product from the tools well and clean them immediately with warm water and soap. If the product dries, it can only be removed with strong detergents. Do not empty the washing liquids into the water table.

WARNING: Wear protective gloves / protective clothing / personal protective equipment for eyes / face. In case of contact with eyes, rinse carefully with plenty of water for several minutes. If contact lenses are present, remove them if easy. Continue rinsing.