Creates a slightly rough surface enhancing adhesion, filling, and homogenization of the substrate, allowing the application of final paste-like coatings. It acts as an organic base substrate (primer) in a certified external wall insulation system.

INSTRUCTIONS FOR USE:

• SUBSTRATE - PREPARATION: The surface must be dry, clean, and free from dust, oils, salts, rust, flaky paints, and residues. Remove any fungi, mold, and algae through mechanical sanding and wash the substrate.
• MIXING: No product dilution is necessary. It is recommended to stir the product before and during application with a low-speed mechanical drill.
• APPLICATION: Apply in one coat using a roller or brush and allow it to dry for at least 4 hours before applying the final decorative coating.
• CLEANING: Tools should be cleaned immediately after application with warm water and soap or a detergent solution.

IMPORTANT REMARKS:

• Tinting is required in the shade of the final coating.
• Do not apply at temperatures below 5°C and above 35°C nor at humidity levels above 65%.
• Surfaces should be protected from sun, wind, and rain.
• Full drying time of 24 hours at a temperature of 25°C and 50% relative humidity.
• Surface drying time of 4 hours at 25°C and 50% relative humidity.