The Ihos QUADRO DSP 6.4 PA power amplifier features built-in DSP with a compressor, limiter, noise gate, parametric equalizer, matrix mixer and delay. Via Ethernet, USB, RS485 or RS232, Mcconsol software enables remote monitoring of the amplifier’s status and real-time DSP adjustment.
- Type: PA power amplifier
- Channels: 4
- Output power: 4 × 1,500 W at 8 Ω, 4 × 2,000 W at 4 Ω
- Bridged output power: 2 × 3,200 W at 8 Ω
- Minimum output impedance: 4 Ω per channel, 8 Ω in bridged mode
- Audio input sources: Analog, sine wave, pink noise, white noise, AES
- Input equalizer: 31 bands
- Matrix DSP: 4 × 4 bands
- Output equalizer: 10 bands
- Crossover filters: Butterworth, Bessel, Linkwitz-Riley
- Input delay: 4 × 80 ms
- Output delay: 4 × 20 ms
- DSP presets: 80
- Audio inputs: 4 balanced XLR inputs
- Outputs: 4 speaker connectors and 4 XLR
- Cooling: Dual fans with intelligent control
- Network protocols: TCP/IP, 1000base-T/100base-TX
- Frequency response: 20 Hz–20 kHz (±0.5 dB) at 1 W, 8 Ω
- Input sensitivity: 12 dB, 6 dB or 0 dB
- Maximum input signal level: 20 dBu (7.75 V)
- Signal-to-noise ratio: 94 dB at 12 dB, 6 dB and 0 dB sensitivity
Technical Specifications
- Amplifier Type
- PA Amplifier
- Type
- Power Amplifier
- Channels
- 4
- Zones
- -
- Power (8Ω)
- -
- Class
- -
Additional Specifications
- Radio
- No
- Cooling system
- No
Connectivity
- RCA
- No
- XLR
- No
- Mini Jack (3.5mm)
- No
- Jack (6.3mm)
- No
- USB
- No
- Ethernet
- No
- Bluetooth
- No
- Mic In
- No
Dimensions
- Width
- -
- Height
- -
- Length
- -
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.