Bright transparent colors for custom finishing and airbrushing. The Candy 2o combines advanced water-based urethane resin technology with crystal clear pigments to create exceptional candy colors.

The Candy 2o is concentrated. Add 10% by volume (9:1 ratio) with 4030 Intercoat for better spray performance. An optional viscosity reduction can be achieved by thinning either with 4012 High Performance.

The Candy 2o is vibrant. 4 – 6 medium wet coats are recommended for full color saturation. Allow each coat to dry properly before the next, approximately 10 minutes of flash time between coats in non-humid, moderate conditions.

The Candy 2o is designed for graphic arts with excellent adhesion so they won't peel or flake when applied. Apply 4030 Intercoat directly over the air-dried Candy 2o to prevent bleed when applying other colors and marking during the adhesion process.

The Candy 2o works with a wide variety of spray guns and airbrushes. The following specifications are suggested as a starting point. As always, the goal is to achieve a fine dispersed spray pattern. Reduce and adjust the settings & psi to achieve a spray pattern that is smooth and free of large color droplets or a "grainy" spray appearance.

• spray gun: 1.2 – 1.3mm nozzle, 25 – 35 psi
• mini-spray gun: 0.8 – 1.0mm, 25 – 35 psi
• airbrush: 0.5mm – mixing with 4030 is generally sufficient, smaller nozzles can be reduced with 4012 High Performance if needed to achieve optimal individual dispersion.