Textures rollers suitable for applying continuous repeating pattern onto clay and bases. Made from transparent PMMA plastic with excellent non-stick properties. Non-toxic. Available in various textures according to specific needs.

• Length: 14.50 cm (5.5 inches)
• Diameter: 2.5 cm (1 inch)

Instructions for Use:

1. Properly mix the putty/clay until it is ready according to the manufacturer's instructions.
2. Extend the putty/clay onto a surface that will be textured. For best results, ensure you have a smooth and flat surface before using the texture rollers.
3. Depending on the type of putty/clay, it is recommended to moisten the texture roller to prevent any sticky situation.
4. Move the texture roller slowly, applying even pressure at all points for a uniform texture.
5. Remove any excess putty/clay with a sharp knife. It is recommended to do this once it has dried to avoid distortions in the putty/clay.

Materials:

Many different types of putty and clay are available on the market, and all can be textured using the correct technique. Usually, polymer clay (such as Fimo or Sculpey) is quite easy to work with these rollers, allowing for easy correction of mistakes before baking. It is recommended to use MDF bases for creating textured bases. The baking time for these clays is approximately 15 minutes at 150°C.

Care Instructions:

After using the texture rollers, use a cleaning brush and plenty of water to remove any residues if necessary.

Safety: To ensure safety, children should be supervised by a responsible adult.