Cashmere Roller with a texture that can press a continuous repeating pattern into clay and putties. Made of transparent PMMA plastic with non-stick properties. Non-toxic. Available in many different textures.

Length: 14.50 cm (5.5 inches)

Diameter: 2.5 cm (1 inch)

Pattern Size: Complex cashmere design with multiple types of fractals and other typical cashmere details.

Usage Instructions:

• Properly mix the putty/clay according to the manufacturer's recommendations.
• Roll out the putty/clay on a smooth surface.
• If necessary, wet the roller to prevent sticking.
• Slowly move the roller applying even pressure for uniform texture.
• Trim any excess putty/clay with a sharp knife, ideally after it dries.

Materials: There are various putties and clays that can take texture with the right technique. Polymer clay (like Fimo or Sculpey) works well with the rollers for correcting errors before baking. For textured bases, MDF bases are preferred as they allow for texture creation directly on them and baking together.

The cooking time for clays is approximately 15 minutes at 150ºC. The MDF may emit a light scent but does not burn.

For epoxy putties, there are various applicable techniques that do not require baking. Green Stuff putty is sticky and slight wetting is recommended before texture application. Other epoxy putties like Milliput are also suitable without excessive wetting.

Care Instructions: After use, clean the roller with a brush and water to remove any residues.

Safety: Children should be supervised by a responsible adult during use.