Usage Instructions:

1. Thoroughly clean the surface on which the mirror will be glued from deteriorated materials and dust. The surface must be completely dry. The suitability of the substrate is crucial for adhesion, and it must belong to the following material categories: chipboard, wood, wall painted with oil-based or plastic paints, concrete, strong plaster. A test of the material's adhesion on each substrate, different from the aforementioned categories, is recommended.
2. Cut the nozzle of the cartridge at an angle to a diameter of 2-3 millimeters.
3. Apply "strips" of the material on the surface where the mirror will be bonded in a vertical direction, parallel to each other, and spaced 5-6 centimeters apart. These "strips" should not be connected to each other to allow air to circulate between the mirror and the substrate, facilitating the polymerization (curing) of the material.
4. Place the mirror and press firmly so that the "strips" of the material are compressed and transformed into filaments. Special attention is needed for the support of the mirror (with adhesive tape) until the material cures and the bonding with the substrate is completed (at least 1-2 days, depending on the conditions).