- Plates made from high-quality polycarbonate

- Special semi-transparent surface

- Plate thickness: 0.5mm

- Colored symbols, numbers, and indicators

- Permanent printing

- The lighting is diffused across the entire surface of the plate

• Although the instrument plates are simply intended to replace the existing factory ones, it is recommended that their installation be done at a professional workshop or electrical shop due to the high sensitivity of the needles (indicators).
• To remove a factory plate, first extract the needle using two spoons to create leverage, as shown in the photos below. Do not apply excessive pressure!
• Then remove the plate using a smooth knife or a similar flat tool.
• Finally, place the new plates and needles in the same position.
• The white instrument plates can be combined with white, red, and blue LED strips for a uniform and impressive lighting.
• For changing the lighting on motorcycles where the instruments are illuminated via a board with integrated SMD, it is recommended to consult a specialized electrical shop.