Car Battery Jumper Cables 300Amp – 2m

Features:

• Heavy-duty copper cables with fully insulated clips
• Two colors: black and red
• Ideal for general use with medium and large vehicle batteries
• Connects to the positive and negative terminals of the battery
• Length: 2m
• Power: 300Amp
• Practical storage bag with zipper

Usage:

• Connect one of the red clips to the (+) terminal of the dead battery and the other red clip to the (+) terminal of the assisting battery.
• Connect one of the black clips to the (-) terminal of the assisting battery and the other black clip to the ground of the disabled vehicle.

Starting:

• Start the engine of the assisting vehicle and keep the RPM high.
• Then, start the engine of the disabled vehicle.
• After each starting attempt, which should not exceed 15 seconds, wait at least 1 minute before trying again.
• After starting, wait 2 to 3 minutes until the engine of the disabled vehicle runs normally.

Disconnecting:

• Disconnect the jumper cables in the reverse order of connection.
• Disconnect the black clip connected to the ground of the disabled vehicle first.
• Then disconnect the other black clip from the (-) terminal of the assisting battery.
• Next, disconnect the 2 red clips in any order.
• Be careful not to let them come into contact with the moving parts of the engine.

Attention: For vehicles with START-STOP, consult the manufacturer’s manual.