The self-adhesive film with a frosted glass appearance is used to ensure privacy, as from any side you look, you will only see shadows. The film is applied to the glass, allows natural light to pass through, and prevents direct sunlight.

Technical specifications of frosted glass self-adhesive film:

• Self-adhesive
• Transparent
• Material - PVC from silicone
• Roll width - 105 cm

Application instructions for frosted glass films:

The films can be applied to mirrors or plexiglass: windows, glass doors, shower cabins. Installation can be carried out in spaces with a minimum temperature of 15 degrees Celsius.

Steps for applying film with water (necessary materials: window cleaning solution, water, dishwashing detergent/shampoo, spray bottle, spatula, cutter, cloth):

• Clean and degrease the glass.
• Prepare the application solution by mixing 1 liter of water with 1 teaspoon of liquid detergent or shampoo.
• Cut the piece of film you need for the window, leaving a 2-3 cm margin.
• Remove the protective sheet from the back of the film, then spray the solution on the back side of the film while removing the protective layer.
• Spray the solution on the window as well, then apply the film and make the necessary adjustments. Start removing the water and air bubbles from the center towards the edges. Using a sharp cutter, cut off the excess material beside the frame.

After application, white spots may appear under the film. These represent a reaction of the adhesive with water and will disappear after drying. The adhesive will dry completely in about 1 week.