The Pulsar Gbic-106 transceiver converts an electrical signal into an optical signal for transmission over single-mode optical fiber at distances of up to 20 km. DDM digital diagnostics monitor the transmitter and receiver voltage, temperature, and optical power in real time. A GBIC-105 module is required to communicate with the second device.
- Type: GBIC
- Quantity: 1
- Transmission speed: 1 Gbps
- Fiber type: Single-mode
- Range: Up to 20 km
- Connection: LC with snap-in latch
- Tx/Rx wavelength: 1550 nm / 1310 nm
- Tx power: -8~-3 dB
- Rx sensitivity: Greater than -22 dB
- Standards and protocols: IEEE 802.3z, 1000 Base-FX
- Operating temperature: 0~70 °C
- Operating humidity: 0~85 %
- Power supply: DC 3.3 V from the SFP port
- Compatibility: TP-LINK, ULTIPOWER, and CISCO devices without protection features
- Form Factor
- GBIC
- Data Transfer Speed
- 1 Gbps
- Transmission Media Type
- -
- Pieces
- 1 pcs
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.