Griffon PVC Gel plastic adhesive bonds pipes, fittings and components made of rigid PVC in pressurised water supply and drainage systems. Its thixotropic formula works quickly, does not drip and fills gaps in loose-fitting joints. It contains no tetrahydrofuran (THF) and is suitable for pipes with a diameter of up to 250 mm and systems rated up to 16 bar (PN 16).
For application, clean the surfaces, then quickly and evenly apply the adhesive to both parts and join them immediately. Do not subject the joint to mechanical stress for the first 10 minutes. Do not use at temperatures ≤ +5°C.
- Type: Plastic adhesive
- Suitable material: Rigid PVC
- Composition: PVC solution in a solvent mixture
- Features: Thixotropic, fast-acting, non-drip, gap-filling
- Tetrahydrofuran (THF): None
- Application: Pipes, fittings and components
- Joint type: Press-fit or loose-fitting
- Systems: Pressurised water supply and drainage
- Pipe diameter: Up to 250 mm
- Maximum pressure: 16 bar (PN 16)
- Maximum gap tolerance: 0.6 mm
- Maximum press-fit joint tolerance: 0.2 mm
- Pipe standards: EN 1329, 1452, 1453 and 1455
- Colour: Clear
- Temperature resistance: 40°C
- Maximum temperature tolerance: 95°C
- Density: Approx. 0.89 g/cm³
- Viscosity: Thixotropic, approx. 1200 mPa·s
- Solids content: Approx. 21%
- Flash point: K1 (<21°C)
- Quantity: 125 ml
- Pieces: 1
- Packaging: Tube
Dimensions
- Type
- Plastic Glue
- Epoxy
- No
- 2-Component
- No
- Packaging Type
- Tube
- High Temperature
- No
- Pieces
- 1 pcs
Capacity
- Quantity
- 125 ml
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.