The Multi Stain Remover product is designed to remove stains and discoloration from iron, copper, manganese, and cobalt in pools. Stains often come from unbalanced water.

Dosing: 1 kg / 50 m³

General Instructions:

• Adjust the pH to 7.0 and ensure that the concentration of the disinfectant is at 0 ppm (mg/l) before application.
• For colored marble finishes or printed liners, avoid direct contact with the surface of the pool. It is recommended:
• To dissolve the product in a clean plastic container and evenly distribute it around the pool with the pump and filter running.
• To place the product in a sock on a telescopic pole, keeping it close to the stained area.
• The product should be applied directly to the stained area or evenly distributed in the pool.
• After removing the stain, add Lo-Chlor No More Metal to the pool water.
• Keep the pump and filter running for at least 24 hours and proceed to thoroughly backwash the filters.
• This treatment reduces pH and Total Alkalinity. After treatment, the water needs to be balanced again.
• To restore balance, start by slowly increasing Total Alkalinity over a period of days.