The Kouvidis CONDUR junction box is designed for surface-mounted electrical installations. Its press-fit lid requires no screws and helps achieve an IP55 protection rating. The box incorporates rodent repellent and antistatic technology.
The pre-cut openings accept CONDUR fittings for conduits, while the four removable outlets on the base allow conduits or cables to pass through. Special guides on the sides help align the box horizontally or vertically with the installation, and a drainage opening can be added.
- Type: Surface-mounted junction box
- Material: PC, with a lid and PE rubber plugs
- Colour: Grey
- Protection rating: IP55
- Dimensions: 67 × 67 × 38 mm
- Openings: 7 with rubber plugs
- Removable base outlets: 4
- Conduit alignment: Horizontal and vertical
- Drainage opening: Available
- Heat resistance: 650 °C
- Temperature resistance range: -25 °C to +60 °C
- Operating voltage: Up to 800 V
- Electrical insulation: Yes
- Flame propagation resistance: Does not propagate flame
- Antistatic technology: Protection against static electricity
- Gases in case of fire: Does not emit toxic or corrosive gases
- Applicable standards: EN 60670-22, EN 50642
- Placement
- Outdoor
- Branching
- Yes
- Plasterboard
- No
- Protection Certification
- IP55
- Colour
- Grey
- Length
- 67 mm
- Width
- 67 mm
- Height
- 38 mm
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.