I am very satisfied. I don't know why it was so difficult for everyone else. Yes, installation is a bit more involved but for edge screens, the whole UV thing is the best. On edge screens, the regular glass doesn't stick well. I installed it twice and it went on just fine. The second time it had a few small marks because I probably used too much glue, but nothing serious. Overall, I'm satisfied and I prefer this for edge screens over regular glass protectors

Attention, because some sites mention that it fits the 50 pro as well... the edges protrude noticeably (some other reviews imply the same for other models) resulting in it becoming even more dangerous.. As for the glues/UV lamp etc., they apply.. very troublesome and the instructions in the packaging obviously target someone very experienced and not beginners. I would not recommend it in any case, I don't know if a "successful operation" makes it immortal, but even with the simple glass (which has two cloths) the phone survives just fine...

I didn't like it. I made 3 attempts, and in the end, I did NOT find the right amount of glue for even and complete coverage of the screen. Ultimately, there were bubbles left. The worst part was that a small amount of glue came off and went into the phone's speaker. I took a while to realize it, and when I made a call, I couldn't hear anything! Fortunately, it cleared up. I think it's a lot of fuss for nothing. Glues, UV lamps... Enough already. You might prefer something else, especially something that doesn't require glue.... However, it did not affect the touchscreen at all. The fingerprint scanner works perfectly, just like when it worked without the glass.

The touch of the screen does not create a problem and seems durable, but to install it, you need to be professionals with many years of experience in glass installation, and even then, if you succeed. The glass does not have glue on it, but rather in a pen that you drop drop by drop onto the screen; then you place the glass, wait until it comes out from all sides of the screen, and then for 30 seconds, you shine the screen with a UV lamp that is included to dry it. Be careful, if you drop a little glue, the glass will not stick and will be ruined; if you drop too much glue, a lot will come out around the screen and will stick to speakers, paddles, etc. If it falls into the phone case, it will destroy it. Also, the curves on the right and left are impossible to stick because they do not fit properly on the curves of the screen.