Artpol steel taps are a set of two M12 hand taps with a 1.75 mm pitch, for threading through and blind holes in carbon and low-alloy structural steels. The set includes a taper tap and a finishing tap in a plastic case.
- Pieces: 2
- Type: Taps
- Material: Steel
- Thread type: Metric, right-hand, coarse
- Thread pitch: 1.75 mm
- Thread angle: 60°
- Number of flutes: 3
- Thread tolerance: ISO2 (6H)
- Standard: DIN-352/2P
- Overall length: 80 mm
- Drive square length: 10 mm
- Drive square diameter: 7 mm
- Recommended hole diameter: 10.2 mm
- Case: Plastic
- Type
- Dies
- with Tap Wrench
- No
- Material
- Steel
- Pieces
- 2 pcs
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.