Perfect. I’m in Athens and I put it on a refrigerator and on 2 air conditioners. Before that I also put a CHP7010W/10 safety plug so I’d be 100% sure the fridge wouldn’t suffer anything, whether from voltage fluctuations, noise, or power outages.
What the Amarad does is 4 things.
1. If the voltage drops below 165 Volt (or whatever you set it to), it cuts off the power because the amperage rises and the fridge may burn out.
2. If the voltage rises above 275-280V (or whatever you set it to) from the normal 220-230, it also cuts off the power so it won’t burn the board.
3. In power outages, if the fridge is running, the freon remains in the circuit and if it starts suddenly, it will see everything. It will burn everything from the board to the compressor. In this case the plug has a time delay before giving power, from 5 seconds up to 5 minutes. I have set it to 3 minutes.
4. It has a display that shows the network voltage at that moment.
Where it sees everything, especially with fridges and air conditioners, is when the power cuts out and comes back after a few seconds. When the network voltage returns, it is not 220V but can reach up to 300 and that burns anything that can’t handle it.
Nowadays, with the way electricity has become in Athens, with the outages, let alone on islands and in some areas of Greece with fluctuations, anything we have with a compressor in the house, like a fridge and air conditioners, is considered necessary.
It is up to 3500W, which means you can put it on any fridge, even a wardrobe-style one, up to a 24000btu air conditioner or even on a washing machine to protect them.
And it doesn’t lose any settings if you unplug it and plug it elsewhere.
Before I put it on the fridge, I put it on a power strip, set it up, and then installed it.
When you plug in the fridge, it won’t start immediately (so don’t get scared).
It will count down to the e.g. 3 minutes you have set and then start.
And without setting anything when you plug it in, it has its own settings that are OK.
Άψογο. Είμαι Αθήνα και
το έβαλα σε ψυγείο και σε 2 κλιματιστικά. Πριν από αυτό έβαλα και ένα πριζάκι ασφαλείας CHP7010W/10 για να είμαι 100% σίγουρος ότι το ψυγείο δεν θα πάθει τίποτα είτε σε αυξομειώσεις τάσης, σε θόρυβο, είτε σε διακοπές ρεύματος.
Αυτό που κάνει ο Amarad είναι 4 πράγματα.
1. Αν πέσει η τάση κάτω από 165Volt (ή ότι εσύ του ορίζεις) διακόπτει το ρεύμα γιατί ανεβαίνουν τα Amper και το ψυγείο ενδέχεται να καεί.
2. Αν ανέβει η τάση πάνω από 275-280V (ή εσύ του ορίσεις) από 220-230 που είναι κανονικά, επίσης διακόπτει το ρεύμα για να μην κάψει πλακέτα.
3. Σε διακοπές ρεύματος και το ψυγείο δουλεύει, το φρέον παραμένει στο κύκλωμα και αν ξεκινήσει απότομα, τα βλέπει όλα. Θα κάψει από πλακέτα μέχρι τον συμπιεστή. Σε αυτή την περίπτωση το πριζάκι έχει χρονοκαθυστέρη να δώσει ρεύμα από 5 δευτερόλεπτα μέχρι 5 λεπτά. Εγώ το έχω ορίσει στα 3 λεπτά.
4. Έχει display που δείχνει την τάση του δικτύου εκείνη την στιγμή.
Εκεί που τα βλέπει όλα ειδικά ψυγείο και κλιματιστικά είναι όταν κόβεται το ρεύμα και απενέρχεται σε κάτι δευτερόλεπτα. Όταν έρχεται η τάση του δικτύου δεν είναι 220V αλλά μπορεί να φτάσει μέχρι και 300 και εκεί καίγεται ότι δεν αντέχει.
Πλέον έτσι όπως έχει γίνει το ρεύμα στην Αθήνα, με τις διακοπές, πόσο μάλιστα σε νησιά και σε κάποιες περιοχές της Ελλάδας με αυξομειώσεις, σε ότι έχουμε συμπιεστή στον σπίτι όπως ψυγείο και κλιματιστικά αυτό θεωρείται αναγκαίο.
Είναι μέχρι 3500W που σημαίνει μπορείς να το βάλεις σε οποιοδήποτε ψυγείο ακόμη και σε ντουλάπα, μέχρι κλιματιστικό 24000btu ή ακόμη και σε πληντύριο ρούχων για να τα προστατέψεις.
Και δεν χάνει καμία ρύθμιση αν το βγάλεις από το ρεύμα και το βάλεις αλλού.
Πριν το βάλω στο ψυγείο το έβαλα σε ένα πολύπριζο, το όρισα και μετά το έβαλα.
Όταν το βάλετε το ψυγείο δεν θα ξεκινήσει κατευθείαν (για να μην τρομάξετε).
Θα μετράει αντίστροφα μέχρι τα π.χ. 3 λεπτά που έχεις ορίσει και μετά.
Και χωρίς να ρυθμίσεις τίποτα όταν το βάλετε, έχει από μόνο του ρυθμίσεις που είσαι ΟΚ.