The Horn M 7x1.00 mm tap set includes a taper tap and a bottoming tap for cutting right-hand metric threads in through holes and blind holes. It is suitable for carbon and low-alloy structural steels and is used by hand.
- Pieces: 2
- Thread type: Metric, coarse, right-hand
- Thread pitch: 1 mm
- Material: Alloy tool steel NC6 (W-1.2063)
- Hardness: 60° HRc (±1°)
- Number of flutes: 3
- Thread angle: 60°
- Standard: DIN 352
- Recommended hole diameter: 6 mm
- Overall length: 56 mm
- Square shank length: 8 mm
- Square shank diameter: 4.9 mm
- Type
- Taper
- with Tap Wrench
- No
- Pieces
- 2 pcs
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.