The case has 3 pre-installed fans that run with molex, meaning you can't control their speed, and they always run at 100%; this is good for temperatures, but some people prefer to control the fan curves. The fans, however, are not that annoying. The case is small and discreet, and aesthetically I really like it. Many say there isn't enough space for the motherboard cables, but personally, everything fit perfectly, and proper cable management was done without any issue at all. My graphics card (rx 6650xt) fit perfectly, with room to spare. But cards over 26 centimeters don't fit, so be careful with that, as it is a smaller case. I personally changed the fan colors from the bios, where if you change the led colors on the motherboard, the fans take on the same color too. If you're looking for a case that is aesthetically beautiful, without taking up much space, this one is irresistible for its price.

For 20 euros it’s really good’
Don’t expect good cable management
The over all case is very sturdy and compact!

good for 20-something euros but you forget to put a big card the airflow is bad but! for 20 euros it's worth it

very good case, it also fits a fairly large gpu. the only problem I had was that the backplate of the motherboard is a bit flexible and I had to push it from behind to get the gpu into place.

zero room for cables making the back panel hard to close
What i like though is that it has a removable front panel and 3 pre installed fans

Small box but for what I needed it for, it's just fine.
It's not for many power supply cables.
Appearance-wise, it's just fine along with an RGB air cooler that I installed

A fine case, but there isn't much space at the back for adding a CPU cooler and I had to cut a part of the case to be able to add it.

I have used it in 3 builds so far.

For its price, it is quite high quality, spacious, and subjectively beautiful.

It should also be noted that the window is tempered glass and not plastic.

Purchased at €27, for a case with tempered glass I believe it is VFM. I got it with the intention of transferring an old full tower computer to a Midi, it will generally be tight for cable management and practical space, but since I managed to fit a dual fan water cooler and a 1060 GPU inside, I think it's just fine for 5 stars.

Almost impossible for good cable management, the fans are okay, for me the graphics card didn't fit, I barely managed to put in another 1050ti gaming x from MSI. You can't make a presentable build with this case. Also, a plus is that it has glass. It's strictly for a budget build, but even then I wouldn't get it because a graphics card doesn't fit. Edit: the real max is 285mm, not 260mm. Edit: it fits a 280mm AIO, specifically the NZXT Kraken X, although I don't think that's even mentioned. UPDATE: the photo is now that I just got the case, absolutely nothing fits inside

It is quite good for its price and of good quality, but don't think it will be like a case costing 80 euros, but it's good, just be careful with the cable management because if you don't do it well and there's a bit of a bulge, the back side of the case will bend [Attention: everything bends very easily]. As for the fans, I can't say anything because they don't need a separate power cable, they get power directly from molex

The case is comfortable and beautiful, but too flimsy, the back cover is very easy to bend without edges like a sheet of tinplate. The front panel where the fans are fixed bends slightly when the bolts are tightened, there is not enough space for wires at the back and I had to tinker. Anyway, the case is beautiful, but you won't feel much pressure during assembly. For its price top

The only bad thing is that the build quality is somewhat low, but for 40€ and 3 fans it is really fantastic

It is value for money, the side is glass, it has good cable management, pay some attention to the length of the cable that powers the CPU, it comes both bare and with 3 fans so be careful which one you choose, it is relatively sensitive to scratches.

It is really a very good case but it has some disadvantages that may outweigh the advantages. Firstly, it is a very beautiful case with built-in ARGB fans, and the build quality is very good with the side glass being real glass and not plexiglass.

Advantages:
- Air filter at the front
- PSU shroud
- USB 3.0 port at the front
- Good quality construction
- Three built-in fans
Disadvantages:
- Fits a graphics card ONLY up to 260mm (26 centimeters)
- Awful space for cable management
- The front panel is not removable (in my experience)
- The reset button did not work for changing colors on my case
- It will not fit an AIO (liquid cooler) as far as I can tell

I believe that if these things do not bother you, you will not have any problem with your purchase
(In my experience, the fans worked perfectly with ASRock Polychrome SYNC)

UPDATES:
The front panel can actually be removed but it takes effort, and the reset button works with the fans only if the 3-pin ARGB header is disconnected.

Beautiful, modern, lightweight, small, spacious, simple yet complete and very practical. Flawless white paint, I would say impeccable. Its chassis and the entire construction are made of very thin sheet metal, so care is needed during setup to avoid potential bending and warping (e.g., when screwing in the fans).

Very nice case
quality construction and regular glass on the side
especially at the 28 euros I paid, there is no better (in my opinion)

Very beautiful with ARGB system fans. The build quality of the panels is obviously proportional to the low price, but overall I was very satisfied with the aesthetics and dimensions of this small case.

Simple construction without anything special. The fans come together and yes, they have RGB. At this price, it's worth the money

If this money (€37) is the best case of Oct/2024. 2 fans in front, 1 in the back, with colors and effects (Molex and they are already connected to the reset for convenience). Good airflow because it is all mesh in the front. Negatives: the top and bottom do not have any dust filters at all, and the cable management on the rear panel does not give you many options because of the space. Be careful that your GPU fits because many triple-fan models will not fit. Compared to a Kolink HF mesh, the only things it has to envy are the filters and the side panel that opens like a little cabinet door. The fact that it has 3 fans compared to 6 that other cases have, I preferred it anyway because of noise but also power consumption, since the airflow is more than enough for budget builds. The filter issue can be solved with 2€ by cutting and screwing on a metal mesh.