The Atte Power IPUPS-5-11-F chassis houses a backup power system for IP CCTV with support for up to 5 IP cameras and a 5P+1UP PoE switch. The ABOX steel enclosure has a removable door with screw locking and a door-opening tamper switch. The 10.8 mm hole grid allows modules to be mounted vertically or horizontally, while cables enter from the rear.
The unit supports 802.3at/af PoE and PASSIVE PoE, with independent electronic protection for each PoE output and automatic recovery after a fault is cleared. Long Range mode transmits data up to 280 m over UTP cable and is disabled by default; changing the mode requires a power restart.
-
Type: Chassis
-
Quantity: 1
-
Colour: White
-
Finish: Semi-matt, electrostatic paint
-
Material: Steel
-
Locking: Screw lock
-
Door: Removable
-
Door-opening protection: Tamper switch
-
Hole grid: 10.8 mm
-
Module mounting: Vertical or horizontal
-
Cable routing: From the rear, with clearance from the wall and space for cable slack
-
Application: IP CCTV system with 5 IP cameras and a 5P+1UP PoE switch
-
PoE devices: 5 devices using 802.3at/af or PASSIVE PoE
-
PoE power per port: Up to 40 W
-
Supply voltage: 12 VDC and 48 VDC
-
Power supply efficiency: 90%
-
Battery compartment: 18 Ah
-
PoE protection: Against short circuits and surges
-
PoE output protection: Independent electronic protection per channel with automatic recovery
-
PoE deactivation: On selected ports
-
Indicators: Visual indicators for power and data transmission
-
Configuration: No parameter configuration required
-
OFF mode: All ports at 100 Mbps, Ethernet up to 100 m
-
ON mode: Ports 1 to 4 at 10 Mbps, range up to 280 m
-
UpLink ports 5 and 6: 100 Mbps in both modes
-
UpLink port 6: Does not support PoE power activation
-
VLAN port isolation: Not available; all ports can communicate with one another
-
Cable for long distances: Cat5e/6
