Ready industrial mortar based on gray Portland cement, graded aggregates from Dionysos marble, and special additives to improve adhesion on difficult surfaces and enhance its rheological properties. Does not contain lime. Requires mixing only with water, reducing preparation time and increasing application speed.

Uses

• For filling and smoothing floors.
• Provides a ready final surface for laying ceramic tiles, marbles, or granites.
• Suitable for indoor and outdoor areas (balconies, roofs, terraces, etc.).
• Does not crack and provides a hard final surface.
• Recommended for thicknesses from 1 to 3 centimeters.

Advantages

• Very high strength.
• Excellent adhesion.
• Resistance to moisture and frost.
• Prevention of cracking.
• Excellent final surface.
• Indoor and outdoor use.
• Speed of preparation and ease of application.
• Excellent workability.
• Consistent quality.

Application Method

• Check the substrate to ensure it is clean, dry, and free from oils or loose and foreign bodies.
• In a clean container, place 5 - 5.5 kg of water and gradually add the contents of the bag, stirring continuously with an electric mixer at low speed (500 rpm) for a homogeneous mass.
• It is necessary to wet the surfaces of the floors with water before and after application.
• The mortar is applied in a thickness of 1 - 3 cm.
• You can walk on the floor after at least 12 hours.
• The installation of marbles or tiles can be done after 48 hours.

Specifications

• European Standard EN 13813 (CT-C7-F2)
• Granulometry: 3 mm.
• Specific weight of fresh mortar: 1950 kg/m³.
• Compressive strength at 28 days: 10.0 MPa. Category C7.
• Flexural strength at 28 days: 2.0 MPa. Category F2.
• Application temperature: +5°C to +35°C.

Packaging

• In 25kg bags.
• On a pallet of 1400 kg, 35 paper bags of 40 kg.
• Bulk in silos with a capacity of 12 - 18 - 22 m³.

Storage

• In intact packaging, in a dry environment, for 12 months from the production date.

Consumption

• Approximately 16 - 18 kg of mortar is needed per m² for 1 cm thickness.

Hazard

• H315 Causes skin irritation.
• H318 Causes serious eye damage.
• H335 May cause respiratory irritation.
• H317 May cause an allergic skin reaction.