Skroutz.mt

Red Silicone Adhesive for High Temperatures 60 ml
Craft Adhesives

Red Silicone Adhesive for High Temperatures 60 ml

For the use of high-temperature silicone glue, follow these steps:

  • Surface preparation: Ensure that the sealing surfaces are clean, dry, and free from dust, oil, or other contaminants.
  • Glue...

For the use of high-temperature silicone glue, follow these steps:

  • Surface preparation: Ensure that the sealing surfaces are clean, dry, and free from dust, oil, or other contaminants.
  • Glue preparation: Cut the plastic nozzle above the thread of the glue tube. Attach the plastic applicator and cut it to the desired size to control the glue flow.
  • Applying...
See Description & Specifications See Description & Specifications
4 70 €
Delivery Wed, 04 Nov - Tue, 10 Nov
14,00 €   shipping cost
Sent from Greece
From PrintezisStore
Greece
See Craft Supplies on the page of PrintezisStore

Learn more about invoicing
Review the product
Product report

Description & Specifications

For the use of high-temperature silicone glue, follow these steps:

  • Surface preparation: Ensure that the sealing surfaces are clean, dry, and free from dust, oil, or other contaminants.
  • Glue preparation: Cut the plastic nozzle above the thread of the glue tube. Attach the plastic applicator and cut it to the desired size to control the glue flow.
  • Applying the glue: Ensure that the width of the joint is between 6 mm and 20 mm. If it is smaller or larger, the applied depth should be adjusted accordingly: For a width of up to 12 mm, maintain a depth of 6 mm. For widths greater than 12 mm, the depth should be half of the width of the joint. Insert the glue into the joint within 5 minutes of opening the tube. Smooth it out with a wet knife or your finger to ensure an even application.
  • Cleaning and finishing: Add a little detergent to the water to facilitate the smoothing of the glue. Remove the paper tape immediately after applying the glue for a clean finish.
  • Drying and curing: Allow the glue to dry completely. The high-temperature resistance of over 250°C is achieved after full drying and can temporarily withstand up to 300°C (approximately 1 hour).
  • Important note: The glue cannot be painted, so plan your application so that the final appearance is acceptable without needing additional painting.
  • Avoid contact with greasy substances, oils, cooling fluids, or fuels, as the glue may swell under these conditions.

These instructions will help you achieve an effective and long-lasting seal in applications exposed to high temperatures.

Manufacturer

Manufacturer Details

Warnings & Safety Information

Specifications

Use
Plastic
Type
Liquid
Type
School / Kindergarten
No Solvents
No

No Solvents

The composition of the glue is environmentally friendly as it is water-based and not solvent-based, making it safe and easy to use. It has minimal to no scent and can be easily removed.

Quantity

Weight
-
Capacity
60 ml
Quantity
1 pcs

Important information

Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.

4,70 €
14,00 €   shipping cost