worth it for its price, its quality as well as its fit

Easy to install, does the job quiet well
No heatgun needed, did both doors on Arosa and still have plenty of material!
Recommended it !

Very easy to use! I placed a second order as well!

Excellent product that was installed with a heat gun and special roll and did its job very well

Very good cutting and placement, the most important thing of all is that if you put it somewhere and then regret it, it comes off relatively easily even after two days. No hairdryer or anything is needed.

Effective and easy to install. Its adhesive is strong and the minimal thickness of the material allows for installation almost anywhere safely and without causing any disturbance. Its price is value for money!

Good for the cost but obviously needs High Density foam to complete the soundproofing/sound absorption package.

Very good and economical. I insulated car doors (one box was more than enough). Small vibrations due to the bass of the speakers stopped and the sound improved exceptionally.

Very good soundproofing. It has a bit of weight as a material, but quite good for the job it does

I put it in the trunk and on the trunk door in combination with foam and it reduced the exhaust noise inside the cabin by 30-40%! It requires patience and surface cleaning. It sticks very well, you don't need a heat gun. I highly recommend it. I only put one layer, but definitely if you put a double layer it's even better, although it adds a lot of weight afterwards. To cover these surfaces you see, I bought two packs, totaling 16 sheets

I put it on the car hood, used 6 sheets, it makes a noticeable difference but don't expect it to completely eliminate the noise. For 18€ + 10€ for the roller, it's worth it.

I got 2 packages (16 pieces in total) and covered the trunk of TOYOTA YARIS 2000 down to under the seats and the rear hood, as much as I could fill it as it is not easy to fit the hand. I used a heat gun and a roller to apply it correctly. I have not yet put them on the rear fog lights as the third package I bought is intended for the front hood. I am quite satisfied as I feel there is more quietness in the cabin and the sound, which is clearly audible, seems to have a lower frequency. When I finish the front hood, I will come back as I have also taken some standard measurements in dB. If there is time and willingness, I think it's worth doing.

Without prior experience with other materials or brands, the installation was particularly easy! Easy to use, to cut pieces, and to apply with the use of a roller, of course. The flooring and the walls of the luggage compartment, as well as the exterior panels of the trunk door, the exterior panels on the front doors, and the rear panels, were all covered. With one layer and coverage, the result is noticeable! Reduced noise and creaks in irregularities and a sense of solidity. It was combined with sound-absorbing foam.

Good material for impact noise. Noticeable difference inside the car and in its acoustics

I had vibrations in the chassis due to the large diameter exhaust pipe mainly from the turbo. I dressed the area around the battery at the back and the problem disappeared. The material applies easily and can be cut with a simple scissors, the application surface must be clean. YES from me..

Impressive result in increasing the performance of the subwoofer, but also in reducing rolling noise.

In Renault Clio iv 2013 model, it did an amazing job. It fit into the car's 4 doors and significantly reduced the sound. Personally, I will also put a hood and a trunk on the spare tire

It takes a lot of patience to install it, but it does the job. The sound outside my 99 Corolla car has been greatly reduced

It was installed on the trunk and rear windows of a Fiat Panda 2008. It significantly reduced road noise and minor vibrations. It was also installed on the doors and improved the feeling of solidity when closing the door. It is easy to install and sticks very well to clean metal surfaces.

Excellent material for its price. If someone wants it thicker, they can put double layer. It sticks firmly and does the job well... I insulated the interior of the car doors, the entire floor of the trunk, and the bottom part of the hood. You can clean dust, etc., stick, use a heat gun, a metal roller to press it properly, and it becomes one with the metal. Super!

It immediately and significantly reduces vibrations and softens the sound of the car, provided that it is properly installed and adequately covers problematic surfaces. Specifically, I installed it in an Audi tt 2001 on the roof, hood, trunk floor, and around the spare tire, driver and passenger doors, rear side panels, and seats. I needed about 10 packs to fully cover the upper surfaces, so for sedans or larger cars, calculate more material (there is also a calculator on the company's website). It is very easy to cut to the desired dimensions and also sticks easily to clean surfaces without much effort. In conclusion, it is worth it and is excellent, but do not have unreasonable expectations from a soundproofing layer.

By placing them strategically in key areas of my old 4x4, such as inside the hood and inside the doors, floor, etc., it greatly reduced the creaking noises and prevented certain panels from synchronizing with the central axis. I even had two extra sheets left