Surface Preparation

• To ensure proper adhesion of the product, the surface to be painted must be cleaned of dust, grease, oils, peeling old paints, rust, mold residues, or moisture.
• For new or porous surfaces, first apply the corresponding recommended primer of the product (Life dur, Life dur water).
• Apply the product in 2 coats, which should be spaced 1 - 2 hours apart.

Application Conditions

• Avoid applying the product at temperatures below 6°C and above 35°C and when the relative humidity is greater than 70% or if there is a likelihood of rain or frost in the next 48 hours.
• Adverse conditions and non-compliance with application instructions can alter the final properties of the product.

Application Tools

• Brush
• Roller
• Paint gun

During work, keep the tools “wet” in the container or with the product. Drain the tools well back into the can and clean them immediately with warm water and soap. If the product dries, it can only be removed with strong detergents. Do not empty the washing liquids into the water table.

Caution: Wear protective gloves, protective clothing, and personal protective equipment for eyes and face. In case of contact with eyes, rinse carefully with plenty of water for several minutes. If contact lenses are present, remove them if easy to do so. Continue rinsing.

Technical Specifications:

• Coverage: 8-12 m² / Lt per coat
• Thinning: First coat: 15% water. Second coat: 5-10% water
• Drying: 1 - 2 hours depending on application conditions