Speargun Shafts

MVD Tahitian Shafts Ø6.50mm Single Flopper Sharkfins 115cm

New heat-treated shafts with low-profile shark fins from MVD. They are made of 17-7 HRC 47 stainless steel, and the welding process is accomplished with lasers.

  • For lengths 80cm to 125cm: Two shark...

New heat-treated shafts with low-profile shark fins from MVD. They are made of 17-7 HRC 47 stainless steel, and the welding process is accomplished with lasers.

  • For lengths 80cm to 125cm: Two shark fins.
  • For lengths 130cm to 150cm: One additional auxiliary shark fin.

The last shark fin on the shaft is located 5cm from the tail.

See full description

Description

Description

New heat-treated shafts with low-profile shark fins from MVD. They are made of 17-7 HRC 47 stainless steel, and the welding process is accomplished with lasers.

  • For lengths 80cm to 125cm: Two shark fins.
  • For lengths 130cm to 150cm: One additional auxiliary shark fin.

The last shark fin on the shaft is located 5cm from the tail.

Manufacturer

See full description

Specifications

Specifications

Type
One Wing, with Sharks
Tahiti
Yes

Important information

Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.

See all specifications

Description & Specifications

New heat-treated shafts with low-profile shark fins from MVD. They are made of 17-7 HRC 47 stainless steel, and the welding process is accomplished with lasers.

  • For lengths 80cm to 125cm: Two shark fins.
  • For lengths 130cm to 150cm: One additional auxiliary shark fin.

The last shark fin on the shaft is located 5cm from the tail.

Manufacturer

Type
One Wing, with Sharks
Tahiti
Yes

Important information

Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.

41,50 €
14,00 €   shipping cost