Hand Taps & Threaders

Nut M16x1.5mm

The Horn ARTPOL M16x1.5 mm die cuts metric, standard, right-hand threads on shafts made of carbon or low-alloy structural steel and cast steel. It has a hardness of 60° HRC (1°), a profile angle of...

The Horn ARTPOL M16x1.5 mm die cuts metric, standard, right-hand threads on shafts made of carbon or low-alloy structural steel and cast steel. It has a hardness of 60° HRC (1°), a profile angle of 60° and an ISO thread tolerance (6g).

  • Type: Die
  • Quantity: 1
  • Material: Steel
  • Thread type: Metric, standard, right-hand
  • Thread: M16
  • Pitch: 1.5 mm
  • Cutting lead:...
See Description & Specifications See Description & Specifications
12 90 €
Delivery Tue, 01 Dec - Mon, 07 Dec
14,00 €   shipping cost
Sent from Greece
From Getters 4.6 (117)

Learn more about invoicing

Description & Specifications

The Horn ARTPOL M16x1.5 mm die cuts metric, standard, right-hand threads on shafts made of carbon or low-alloy structural steel and cast steel. It has a hardness of 60° HRC (±1°), a profile angle of 60° and an ISO thread tolerance (6g).

  • Type: Die
  • Quantity: 1
  • Material: Steel
  • Thread type: Metric, standard, right-hand
  • Thread: M16
  • Pitch: 1.5 mm
  • Cutting lead: 1.75P
  • Hardness: 60° HRC (±1°)
  • Profile angle: 60°
  • Outer diameter: 45 mm
  • Thickness: 18 mm
  • Chip holes: 3
  • Recommended shaft diameter: 15.8 mm
  • Standards: DIN-EN 22 568, ISO DIN-13
  • Thread tolerance: ISO (6g)

Manufacturer

Type
Dies
with Tap Wrench
No
Material
Steel
Pieces
1 pcs

Important information

Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.

12,90 €
14,00 €   shipping cost