Note: Leak Sealer should not be used when the pool water temperature is below 6 degrees Celsius (°C).

1. Turn off the pool pump. Remove any automatic robot from the pool.
2. Set the filter to BY-PASS or RECIRCULATE mode. If neither of these settings is available, remove the Cartridge filter before treatment.
   Note: Leak Sealer may block jets. If the jets cannot be removed before use, do not use this product.
3. Leak Sealer should be added at a rate of 1 liter per 60,000 cubic meters of water. There are two application methods for Leak Sealer depending on the leak location.
   (A) LEAK ON THE POOL SURFACE: If possible, locate the leak area and add the product directly to that area. Otherwise, distribute the product evenly around the pool.
   (B) LEAK IN PIPES: Add the correct dose into the skimmer. Place a suction hose at the deepest point of the pool. Ensure the suction hose is free of air before application.
4. If you are unsure of the leak location, use the above method (B).
5. Wait 30 minutes, then turn the pump back on. Run the pump for at least 8 hours.
6. Record the water level and check after 24 hours.
7. Allow all residues to settle (within 6 hours) and then wipe clean.
8. For larger pools or if water loss has decreased, a second application may be necessary.

• Very easy and cost-effective to use
• Can prevent unwanted expenses for unnecessary projects
• Concentrated formula
• Available in 1L

• Dosage: 1 L / 60 m3
• Frequency: Treatment