This means that it stops the pump's operation as soon as it detects that the tank, well, or water source we are drawing from is empty or has run out, and the pump is about to draw air. It immediately stops its operation to prevent damage.
Description
Specifications
Fully automatic pump unit with peripheral pump and electronic pump control device. Suitable for water supply in homes that do not have a municipal water network or where the municipal network does not provide sufficient pressure. For irrigation, garden watering, small industrial installations, and anywhere else where water pressure boosting is required.
Electronic water controller is the electronic device installed on the pump (single-phase or three-phase) in any position, vertical or horizontal, depending on the flow, and automates the start after a pressure drop (opening a tap) and stops when the flow is interrupted at the maximum pressure level of the electric pump (closing the tap). It also has the ability to control pumps from 0.5Hp to 2Hp.
Suitable for water supply in homes that do not have a municipal water network or where the municipal network does not provide sufficient pressure. For irrigation, garden watering, small industrial installations, and anywhere else where water pressure boosting is required.
The operation of the pump is controlled by the electronic control device Brio 2000-M. The pump starts when the pressure drops to the lower limit of the pressure switch and stops when the pressure rises again to the upper limit. The motor features a solid copper winding and a compact, user-friendly design.
Protection against dry operation
This means that it stops the pump's operation as soon as it detects that the tank, well, or water source we are drawing from is empty or has run out, and the pump is about to draw air. It immediately stops its operation to prevent damage.
Advantages of the Brio 2000-M electronic control device:
- Automatic reset in case of dry operation by simply pressing a button.
- Overpressure protection capable of stopping the electric pump at a set limit.
- Can protect against moisture problems thanks to the electronic circuit housed in an airtight enclosure.
Technical Specifications:
- Type: PKm 65
- Power: 0.75 HP - 550 Watt
- Nozzle: 1" x 1"
- Pump material: Cast iron
- Impeller material: Brass
- Voltage: 220V/50Hz
- Maximum flow rate: 3000 L/h
- Manometric height: 55m max
- Suction depth: 8m
- Maximum pressure: 5.5 bar
- Liquid temperature: 60°C
Includes:
- Single-phase peripheral pump Pedrollo PKm 65 0.75Hp, click on the photo to see more features.
- Electronic pump control device Brio 2000-M, click on the photo to see more features.
It is recommended to use an expansion tank in conjunction with the electronic controller for the following reasons:
- Prevents frequent pump startups
- Ensures smooth flow without fluctuations in the network
- Prevents damage to the hydraulic parts of the pump and installation
- Prevents air entrapment in the system
- Lower electricity consumption
- Power Source
- Single Phase
- Horsepower
- 0.75 hp
- Power
- 550 W
- Inverter
- No
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.