Skroutz.mt

15kV High Frequency DC High Voltage Arc Ignition Generator Inverter Boost Transformer 3.7V DIY Kit
Misc Electronics

15kV High Frequency DC High Voltage Arc Ignition Generator Inverter Boost Transformer 3.7V DIY Kit

High Voltage Arc Generator 15KV

Product Introduction:

  • Dimensions: 29*24*18mm
  • Requires 12V, with resistance base adjustment from 150 ohm to 1.5K ohm.
  • The resistance should vary from high to low,...

High Voltage Arc Generator 15KV

Product Introduction:

  • Dimensions: 29*24*18mm
  • Requires 12V, with resistance base adjustment from 150 ohm to 1.5K ohm.
  • The resistance should vary from high to low, without being too low to avoid burning the triode or the product.
  • It should not be too high, as it will affect the output performance.
  • Maximum output: 15kV, with a...
See Description & Specifications See Description & Specifications

Learn more about invoicing
Review the product
Product report

Description & Specifications

High Voltage Arc Generator 15KV

Product Introduction:

  • Dimensions: 29*24*18mm
  • Requires 12V, with resistance base adjustment from 150 ohm to 1.5K ohm.
  • The resistance should vary from high to low, without being too low to avoid burning the triode or the product.
  • It should not be too high, as it will affect the output performance.
  • Maximum output: 15kV, with a limited output that must not exceed 15kV (arc 1.5cm) to avoid product damage.
  • The use of wax or epoxy resin insulation is recommended for continuous operation.

Features:

  • Easy construction with a simple and reliable circuit design.
  • Uses: experiments, electronic devices, negative ion generator, small scientific productions.
  • Creates a stable high-frequency arc that can ignite flammable materials.

Parameters:

  • Transformer dimensions: 27×16×21mm
  • Input: DC 3.7V-4.2V (maximum 12V, requires resistor adjustment).
  • Input current: <2A
  • Output voltage: approximately 15KV.
  • Output current: ≤0.4A
  • Ignition distance: ≤0.5 cm

Deletion and Layout:

  • Two primary coils and one feedback coil.
  • The PCB dimensions are: 4.2CM * 3.2CM * 0.16CM.

Includes:

  • 15VKE step-up transformer x1
  • PCB Board x 1
  • Resistor 120 ohm x 1
  • UF4007 fast recovery diode x 1
  • Triode N20 x 1
  • Heatsink x 1
  • M3 * 6 screws x 1
  • Switch x 1
  • 3-Pin x 1

Manufacturer

Manufacturer Details

Warnings & Safety Information
Type
Generator
Packaging
1 pcs
Operating Voltage
12 V
Ecosystem
-

Important information

Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.

3,47 €
14,00 €   shipping cost