Car Audio Amplifiers

Max Pa1-500.4dz1 Four-Channel Car Audio Amplifier 4ch Gas Audio Power

The Max PA1-500.4dz1 four-channel car amplifier uses a full-range Class D circuit and can be connected to a subwoofer, driver, tweeter or coaxial speakers. The VCC (Vented Cross Cooling) system...

The Max PA1-500.4dz1 four-channel car amplifier uses a full-range Class D circuit and can be connected to a subwoofer, driver, tweeter or coaxial speakers. The VCC (Vented Cross Cooling) system continuously directs cool air over the components and expels hot air through the openings on the opposite side of the chassis.

The adjustable high-pass and low-pass...

See Description & Specifications See Description & Specifications
423 00 €
Delivery by Fri, 13 Nov
14,00 €   shipping cost
Sent from Greece
From PSAudio Autosound Systems 5.0 (91)

Learn more about invoicing

Description & Specifications

The Max PA1-500.4dz1 four-channel car amplifier uses a full-range Class D circuit and can be connected to a subwoofer, driver, tweeter or coaxial speakers. The VCC (Vented Cross Cooling) system continuously directs cool air over the components and expels hot air through the openings on the opposite side of the chassis.

The adjustable high-pass and low-pass filters allow you to adjust the frequency, while Bass EQ on channels 3 and 4 adjusts the low frequencies. The power supply stabilizes the voltage and monitors changes in the car battery. The protection circuit covers overheating, short circuits and overload, and includes a turn-on delay. The Clip LEDs indicate the output level, and the protection circuit activates when distortion exceeds 1%.

  • Number of channels: 4
  • Amplifier class: D
  • RMS power at 1 Ω: 4 × 500 W
  • RMS power at 2 Ω: 4 × 350 W
  • RMS power at 4 Ω: 4 × 200 W
  • Frequency response: 15–22000 Hz
  • Low-pass filter: 50–6000 Hz
  • High-pass filter: 15–6000 Hz
  • Bass boost: 0–12 dB at 45 Hz, on channels 3 and 4
  • Crossover slope: 12 dB
  • Input mode: 2-channel or 4-channel
  • Input sensitivity: 0.2–10 V
  • Power supply voltage: 10–16 V
  • REM voltage: 10–16 V
  • Signal-to-noise ratio: >92 dB
  • Damping factor: >120
  • Speaker wire terminals: 8 AWG (10 mm²)
  • Power and ground connections: 0 AWG (50 mm²)

Manufacturer

Number of Channels
4 Channels
Output Power (4 Ohm)
-
Amplifier class
D

Important information

Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.

423,00 €
14,00 €   shipping cost