The No Frost Heating Cable 50m pipe heating kit switches on automatically below +3 °C and switches off above +15 °C. It includes a heating cable with a stranded heating conductor, a thermostat and a power cord with plug. It can be installed on steel, copper and plastic pipes, provided the material can withstand operating temperatures of up to +90 °C.
The cable is designed to protect pipes, gutters, valves, meters and drainage pits from frost, as well as to protect roof edges from the accumulation of snow and ice. It can also maintain the temperature of liquids in tanks and pipes, preventing them from freezing. During installation, the thermostat is secured in direct contact with the coldest point of the pipe, while the cable is laid along it and secured every 30 to 60 cm. After installation, the protected section is covered with thermal insulation.
- Type: Pipe frost protection kit
- Heating cable length: 50 m
- Power cord length: 2 m
- Power per metre: 16 W/m
- Total power: 800 W
- Power supply: 230 V
- Cable diameter: 8 mm
- Thermostat: Built-in
- Switch-on temperature: Below +3 °C
- Switch-off temperature: Above +15 °C
- Protection rating: IPX8
- Installation: Under thermal insulation
- Plug: Waterproof
Dimensions
- Type
- Thermostat
- Compatibility
- -
- Construction Material [Pharmaceutical]
- Inox
- Smart / WiFi
- No
Technical Parameters
- Thread / Cross-section
- -
- Power
- 16 W
- Maximum Pressure
- -
Important information
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.